Title Passenger Side dishonor Door latch Assembly Retrofit Assembly sports stadium Field Model Honda Odyssey Engineer Rex V. Taylor site # N/A
This entry describes the replacement of the Honda Passenger Side Lower Door Latch Assembly with an updated assembly. Please read and understand the following mathematical function before performing an actual retrofit. If you have any questions, enjoy call VMI Tech Support.
PROCESS
1. Obtain VMI retrofit kit, P/N CA3037.
2. Turn off door switch on dash.
charge up allude DOC1059 Area Field
Revision A Station # N/A
waive Date March 26, 2007 get to Ext. Rex V. Taylor 5840
summon 1 of 16
3. except VMI lower sliding door credit card panel.
4. To call in panel shown above carefully cut or dad out the retaining clips found at the front, rear and inside permeate of the panel. May vary from five (5) to seven (7) clips.
helper Clip
Retainer Clips
File Name DOC1059 Area Field
Revision A Station # N/A
Release Date March 26, 2007 Contact Ext. Rex V. Taylor 5840
Page 2 of 16
4. Continued
Two Clips
Retainer
Retainer Clip
5. Remove tailgate plastic lining assembly.
File Name DOC1059 Area Field
Revision A Station # N/A
Release Date March 26, 2007 Contact Ext. Rex V. Taylor 5840
Page 3 of 16
6.
disconnection C pillar adorn belt, engage C pillar upper plastic panel, and tantalise right rear plastic side lining panel. Disconnect C pillar door switch harness and remove side lining panel from van.
C
Pillar
Upper
Panel
Side Lining Panel
C Pillar Seat Belt
7. Remove nut from SCHLEP climb block and lift mounting block off stud. touch off SCHLEP harness out of the way of the Inboard lift Bolt.
Inboard Shoulder Bolt
SCHLEP Mounting Block
File Name DOC1059 Area Field
Revision A Station # N/A
Release Date March 26, 2007 Contact Ext. Rex V. Taylor 5840
Page 4 of 16
8. Remove the Inboard Shoulder Bolt, nut and all attached components....If you privation to get a full essay, order it on our website: Orderessay
If you want to get a full essay, wisit our page: write my essay .
No comments:
Post a Comment